Faq Concerning Rechargeable Battery [laptop, Mobile, Etc]_2.

1 - It is said that the 1st time we use a device furnished with a lithium laptop power (as I say, they might be called Li-ion) should be allowed to charge for eight or simply ten hours, but a few hours (typical time charging of such batteries), the device will indicate that this battery is fully billed.

There, that was recommended when you use Ni-MH batteries, but aided by the Li-ion is not absolutely necessary: a lithium battery always carries a protection circuit against overloads which strengthens turning off the power once detecting the cells that define the battery has reached the normal level (usually from some. 2 volts). Therefore, once the device says "full charge" no more current enters the Dell vostro 1710 battery and n't have any effect on it, the better time to leave this charger attached.



2. They say also that going barefoot should make complete charge and discharge in order to avoid "memory effect" in Ni-MH batteries was when we put to charge a battery is completely discharged was not lost within the capacity of battery from overcharging a bit of its cells.

In Li-ion batteries is absolutely not needed, and even more frequently as recommended load plus the cells are less time with current flowing by them. Li-ion Dell vostro 1720 battery have zero memory effect and therefore one can load as best we please and not wait until they are completely soldout as it did when using the old batteries.

3 - Web site of things that are the worst thing that may make a lithium battery:

鈥? The warmth: Li-ion Dell vostro 1510 variety loses capacity when located in hot areas. A great deal more be more cold, although kept below 30 degrees Celsius is well over acceptable. That is why the actual batteries of some laptops will degrade right away if the design will not be taken into account how the battery area should end up being cool, ie, away through the hard drive and microprocessor...

路 Store a long time fully charged: it is best to keep a electric battery at half load, if we exercise with fully charged your cells will suffer and the battery will deteriorate over time. Not much time need to be stored fully discharged for what we will have in the next action.

路 Leave the battery entirely discharged, if a Li-ion Dell vostro 1520 battery pack reaches completely lost its charge won't reload. This point is not reached when the device is turned off considering that the battery has a minimal level of energy since that strengthens the above-mentioned circuit safety. Over time the power supply is losing charge on their own (coefficient of self) if left unfilled for lots of months may lower the minimum threshold necessary to begin charging and the particular battery unusable.

4. The Li-ion batteries have plenty of life cycles (charge-discharge) who grown to be about 500 to 1000

500-1000 is assumed that after charging and discharging any Compaq Presario V6000 battery has reached 70% capacity, but gas 4 free : must add the capacity loss a result of the time the heat along with the stored charge (the about three points discussed above). Not a single thing lasts forever, and the batteries tend not to escape this universal rules. By the way, never intent茅is remove such types of batteries, they are particularly unstable under certain illnesses (that carry the recognized circuit protection, circuit fails or handled will lead to the explosion of the battery as happened recently with some models notebooks pre-loaded with faulty batteries. )

5. It happens to be true that the power supply should take several series of charge / discharge before achieving peak operation?

No. This type of battery does not require a "break-in interval. " Enjoy full capacity out of your outset.

6. I have a very PDA or mobile mobile, does it load because transformer using the HARDWARE cable?

DEPENDS. Some computers can not maintain the amperage had to charge its Compaq Presario V3000 electric battery, so it might take for a long time. The charger will always provide just enough to charge the product, optimizing the load time.